Thiết bị đo cơ khí chính xác
Thiết bị đo điện
Thiết bị đo tần số, vô tuyến
Thiết bị quan trắc môi trường
Thiết bị kiểm tra không phá hủy
Thiết bị phòng thí nghiệm
Thiết bị, máy móc công nghiệp
Tất cả danh mụcTECOTEC GROUP
SINEAX B812
LIÊN HỆ
Vui lòng liên hệ để nhận báo giá phù hợp
Yêu cầu báo giá
LIÊN HỆ ĐỂ CÓ GIÁ TỐT
Thanh toán an toàn
Hỗ trợ chuyên nghiệp
Đổi trả dễ dàng
Giao hàng tận nơi
The SINEAX B812 unit supplies all commercially available 2-wire field
transmitters.
The B812 unit supplies 2-wire transmitters and provides the 4 – 20 mA
signal galvanicly separated at the output. The separation is HART penetrable,
i.e. you can parameterise or read out intelligent transmitters via HART or
customised protocols. Two power supply versions with wide area power packs
ensure the connection to all common power supplies.
It is one of the smallest products on the market. Nevertheless, we did
not make any compromise in relation to safety. The unit embodies galvanic
isolation between all circuits and complies with the whole range of EN 61 010 or
IEC 1010 requirements. The intrinsically safe design connects to all field
instruments in explosive gas or dust atmospheres (Zones 0, 1, 2 or 20, 21, 22).
- Patented contactless capacitive system, wear-free
- Measuring range, direction of rotation, characteristics, output changeover and other functions can be programmed via PC: facilitates planning and project work, short lead times, minimal inventory
- Angle of rotation measuring range: 0°...10° to 0°...50° or 0°...50°
to 0°...350°
With gearbox 0...20° to 0...1555 revolutions
Measurement output (measuring/supply circuit) utilizes 2-wire connection (4 to 20 mA signal) - Simulation of measured value allows to test subsequent control circuits, control loops or measuring circuits during installation
- Display of present measurands and graphical representation on screen for
longer time periods
Adjustment of mechanical position and fine adjustment of the analog output, zero point and span may be set independently - Programmable output characteristics: linear, V-characteristic or freely selectable linearization curve
- Shaft can be turned through full, no damage occurs even if the upper limit value of the measuring range is exceeded
- Serial interface
- Permissible static load on the shaft: max. 1000 N (radial), max. 500 N (axial)
- Surface mounting device in rugged housing (IP67): vibration and shock resistant
Cần tư vấn hoặc báo giá? Chuyên gia của chúng tôi phản hồi trong 2 giờ làm việc.
30 năm kinh nghiệm · Hơn 500 dòng thiết bị đo lường · Hỗ trợ kỹ thuật trọn vòng đời sản phẩm
1 / 1