The innovative new SYSKON series of KONSTANTER power supplies provides you with top quality, programable and manual and remote controllable DC power supplies for laboratory and system use.

Equipped with active power-factor control (PFC), it supplies 500 through 4500 W of power at up to 60 V and max. 180 A with characteristic UIP curve.

Special switching controller technology and matching status controllers assure high dynamics and short response times. The setting range for output voltage and output current can be restricted by specifying setting limits.

The analog interface is equipped with two programmable trigger inputs and three signal outputs, which can be linked to various device functions for indication, or for controlling external devices and an auxiliary power output. Beyond this, monitor outputs and control inputs for voltage and current setpoints are available as well. Sensing leads allow for auto-sensing operation at the power consumer. Strict menu-driven operation supports highly diverse programming functions. The device is transformed into a freely programmable test signal generator by means of an expanded sequence memory and extra functions.

• Wide range of functions
• Comprehensive calibration report
• Minimal power loss
• Auto-ranging output with 120, 240 or 320 W
• Voltage and current regulated output
• Increased output power for brief intermittent periods
• Very short response time thanks to BET technology
• Dynamic sink mode operation
• Excellent dynamic control parameters
• Minimal residual ripple
• Output ON/OFF function
• Lockable control elements
• Master-slave operation with parallel or series connection
• Sequence controls for the generation of voltage and current sequences
• Protection against overvoltage, overcurrent and excessive temperature
• Calibration procedure for menu-driven balancing
• RS 232 interface (complete device operation) / analog interface
• Floating output terminals at front and rear panel
• Can be electrically and mechanically combined with multi-output devices
 
 
Options:
• IEEE 488 interface
• Driver software for LabVIEW, LabWindows and HP VEE